Volume 4, Issue 3 (2020)
IQBQ 2020, 4(3): 42-27 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Ebrahimi N, bagheri G. Design and optimization of metformin released from ZnO/Chitosan nanocomposite. IQBQ 2020; 4 (3) :42-27
URL: http://arcpe.modares.ac.ir/article-38-40935-en.html
URL: http://arcpe.modares.ac.ir/article-38-40935-en.html
1- Shahryar Branch, Islamic Azad University
2- Shahryar Branch, Islamic Azad University ,bagheri.gita@yahoo.com
2- Shahryar Branch, Islamic Azad University ,
Abstract: (3130 Views)
Metformin enhances insulin's effect and increases cells’ sensitivity to insulin. In this paper, nanocomposite was designed and used in the metformin release system, which was able to release the required drug in a controlled manner. In this research, nanoparticles of zinc oxide (ZnO) were prepared via the sol-gel method. The experimental design central composite response surface method was applied for the optimization of the nanoparticles based on varied variables such as the weight of zinc acetate (gr) (X 1) and the volume of triethanolamine (ml) (X2). The particle size of the optimized nanoparticle was reported to be 28 ± 21.27 nm; zeta potential and PdI were 25.54 ± 1.64 mV, 0.168 ± 0.05 respectively. The chitosan polymer was used to improve environmental compatibility and increase drug release control; finally, metformin was loaded on the optimized nanocomposite. Structural properties were analyzed using scanning electron microscopy (SEM) X-Ray Diffraction (XRD), Fourier-transform infrared spectroscopy (FT-IR), and Dynamic Light Scattering (DLS). The SEM images showed that the average nanocomposite size was 40 nm. The results of XRD patterns and SEM images were also consistent with each other and the average particle size was the same. Infrared spectrophotometry showed the presence of chitosan used to coat nanoparticles on their surfaces and confirmed the loading of metformin. An in-vitro metformin release from the nanocomposite was conducted in PBS (pH=7.4) and analyzed by a spectrophotometer at 233 nm. Metformin has a high solubility in water, and since it is difficult to prepare a slow release form of high-solubility drugs, the aim of this study was to design a slow-release formulation of metformin with a suitable profile that could control release without explosive release for up to 120 hours.
Article Type: Original Research |
Subject:
Drug delivery
Received: 2020/02/24 | Accepted: 2020/05/9 | Published: 2021/01/2
Received: 2020/02/24 | Accepted: 2020/05/9 | Published: 2021/01/2
Send email to the article author
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |