The role of hierarchical Y zeolites on the catalyst performance of diesel Hydrodesulfurization Process

Document Type : Original Research

Authors

1 Department of Chemical and Petroleum Engineering, Sharif University of Technology, Tehran, Iran

2 Catalysis Technologies Development Division,Research Institute of Petroleum Industry (RIPI), Tehran, Iran

3 Catalysis Technologies Development Division, RIPI, Tehran, Iran

Abstract
Research subject: Hydrodesulfurization is one of the effective methods to remove sulfur compounds from oil fractions and improve fuel quality. One of the major challenges in this process is to find the proper catalyst support that performs best. In the meantime, modified supports with zeolite have allocated a lot of attention due to their strong acidic sites, specific surface area and high hydrothermal and chemical stability; But the acidity and volume of zeolite mesopores need to be corrected.

Research approach: In this study, first, hierarchical Y zeolite was prepared using post-synthesis (Dealumination) and using ammonium form of zeolite and NH4F solution (0.75 M) at 90˚C for 3h under reflux conditions. Physicochemical properties of zeolite were investigated by BET, FESEM, FTIR, AAS and XRD analyzes. Modified zeolites were used in the support synthesis of the HDS process catalyst. The sulfidation and performance evaluation of the prepared catalysts were carried out in the fixed-bed microreactor were performed with diesel cutting feed from the Isomax unit of the target refinery.

Main results: The results show that the volume of mesopores, specific surface area and SiO2/Al2O3 ratio in hierarchical zeolites has increased 0.073 cm3 g-1, 783.36 m2 g-1 and 5.2, respectively (initial values are 0.032 cm3 g-1, 567.18 m2 g-1 and 4.5). The results of zeolite analysis show the preservation of the structure and crystallinity during the zeolite modification process. The effect of zeolite modification, especially the Si/Al ratio variations, mesopores and specific surface area, was investigated on the activity of NiMo/Zeolite+Al2O3 catalysts. Increasing the acidity and improving the physicochemical properties of the modified zeolites has increased the catalyst performance in the process of diesel hydrodesulfurization (Conversion= 90%). Improving the activity of catalysts can be attributed to the positive effect of zeolites on the dispersion of the metallic site, surface area, acidity, optimal size of pores and volume of catalyst mesopores.

Keywords

Subjects


[1] Han W, Nie H, Long X, Li M, Yang Q, Li D. Effects of the support Brønsted acidity on the hydrodesulfurization and hydrodenitrogention activity of sulfided NiMo/Al2O3 catalysts. Catal Today 292:58–66; 2017.
[2] Zhou W, Wei Q, Zhou Y, Liu M, Ding S, Yang Q. Hydrodesulfurization of 4, 6-dimethyldibenzothiophene over NiMo sulfide catalysts supported on meso-microporous Y zeolite with different mesopore sizes. Appl Catal B Environ;238:212–24; 2018.
[3] Qin Z, Shen W, Zhou S, Shen Y, Li C, Zeng P, et al. Defect-assisted mesopore formation during Y zeolite dealumination: The types of defect matter. Microporous Mesoporous Mater;303:110248; 2020.
[4] Zhou W, Liu M, Zhou Y, Wei Q, Zhang Q, Ding S, et al. 4, 6-Dimethyldibenzothiophene hydrodesulfurization on nickel-modified USY-supported NiMoS catalysts: effects of modification method. Energy & Fuels;31:7445–55; 2017.
[5] Verboekend D, Nuttens N, Locus R, Van Aelst J, Verolme P, Groen JC, et al. Synthesis, characterisation, and catalytic evaluation of hierarchical faujasite zeolites: milestones, challenges, and future directions. Chem Soc Rev;45:3331–52; 2016.
[6] Verboekend D, Vilé G, Pérez-ramírez J. Hierarchical Y and USY Zeolites Designed by Post- Synthetic Strategies:916–28; 2012.
[7] Shirvani S, Ghashghaee M, Kegnæs S. Dual role of ferric chloride in modification of USY catalyst for enhanced olefin production from refinery fuel oil. Appl Catal A Gen;580:131–9; 2019.
[8] Stanislaus A, Marafi A, Rana MS. Recent advances in the science and technology of ultra low sulfur diesel (ULSD) production. Catal Today;153:1–68; 2010.
[9] Li H, Wu H, Shi J. Competition balance between mesoporous self-assembly and crystallization of zeolite: a key to the formation of mesoporous zeolite. J Alloys Compd;556:71–8; 2013.
[10] Fu X, Sheng X, Zhou Y, Fu Z, Zhao S, Bu X, et al. Design of micro–mesoporous zeolite catalysts for alkylation. RSC Adv;6:50630–9; 2016.
[11] Li K, Valla J, Garcia-Martinez J. Realizing the commercial potential of hierarchical zeolites: new opportunities in catalytic cracking. ChemCatChem;6:46–66; 2014.
[12] Pérez-Ramírez J, Christensen CH, Egeblad K, Christensen CH, Groen JC. Hierarchical zeolites: enhanced utilisation of microporous crystals in catalysis by advances in materials design. Chem Soc Rev;37:2530–42; 2008.
[13] Fu W, Zhang L, Tang T, Ke Q, Wang S, Hu J, et al. Extraordinarily high activity in the hydrodesulfurization of 4, 6-dimethyldibenzothiophene over Pd supported on mesoporous zeolite Y. J Am Chem Soc;133:15346–9; 2011.
[14] Tang T, Zhang L, Dong H, Fang Z, Fu W, Yu Q, et al. Organic template-free synthesis of zeolite Y nanoparticle assemblies and their application in the catalysis of the Ritter reaction. RSC Adv;7:7711–7; 2017.
[15] Zhang Z, Wang Q, Chen H, Zhang X. Hydroconversion of waste cooking oil into green biofuel over hierarchical USY-supported NiMo catalyst: a comparative study of desilication and dealumination. Catalysts;7:281; 2017.
[16] Gackowski M, Tarach K. Kuterasiński Ł., Podobiński J., Jarczewski S., Kuśtrowski P., Datka J. Hierarchical zeolites Y obtained by desilication: Porosity, acidity and catalytic properties. Microporous Mesoporous Mater;263:282–8; 2018.
[17] Feng A, Yu Y, Mi L, Cao Y, Yu Y, Song L. Synthesis and characterization of hierarchical Y zeolites using NH4HF2 as dealumination agent. Microporous Mesoporous Mater;280:211–8; 2019.
[18] Qin Z, Shen B, Yu Z, Deng F, Zhao L, Zhou S, et al. A defect-based strategy for the preparation of mesoporous zeolite Y for high-performance catalytic cracking. J Catal;298:102–11; 2013.
[19] Silaghi M-C, Chizallet C, Sauer J, Raybaud P. Dealumination mechanisms of zeolites and extra-framework aluminum confinement. J Catal;339:242–55; 2016.
[20] Guefrachi Y, Sharma G, Xu D, Kumar G, Vinter KP, Abdelrahman OA, et al. Steam‐Induced Coarsening of Single‐Unit‐Cell MFI Zeolite Nanosheets and Its Effect on External Surface Brønsted Acid Catalysis. Angew Chemie Int Ed;59:9579–85; 2020.
[21] Ren S, Meng B, Sui X, Duan H, Gao X, Zhang H, et al. Preparation of Mesoporous Zeolite Y by Fluorine–Alkaline Treatment for Hydrocracking Reaction of Naphthalene. Ind Eng Chem Res;58:7886–91; 2019.
[22] Asadi AA, Alavi SM, Royaee SJ, Bazmi M. Dependency of acidic and surficial characteristics of steamed Y zeolite on potentially effective synthesis parameters: screening, prioritizing and model development. Microporous Mesoporous Mater;259:142–54; 2018.
[23] Baerlocher C, McCusker LB, Olson DH. Atlas of zeolite framework types. Elsevier; 2007.
[24] Chester AW, Derouane EG. Zeolite characterization and catalysis. vol. 360. Springer; 2009.
[25] Asadi AA, Royaee SJ, Alavi SM, Bazmi M. Ultra-deep hydrodesulfurization of cracked and atmospheric gasoil blend: Direct and interactive impacts of support composition, chelating agent, metal and promoter loadings. Fuel Process Technol 2019;187:36–51.
[26] Lutz W, Rüscher CH, Heidemann D. Determination of the framework and non-framework [SiO2] and [AlO2] species of steamed and leached faujasite type zeolites: calibration of IR, NMR, and XRD data by chemical methods. Microporous Mesoporous Mater;55:193–202; 2002.
[27] Deng C, Zhang J, Dong L, Huang M, Li B, Jin G, et al. The effect of positioning cations on acidity and stability of the framework structure of Y zeolite. Sci Rep;6:1–13; 2016.
[28] Zhang D, Jin C, Zou M, Huang S. Mesopore Engineering for Well‐Defined Mesoporosity in Al‐Rich Aluminosilicate Zeolites. Chem Eur J;25:2675–83; 2019.
[29] van Haandel L, Bremmer M, Kooyman PJ, Van Veen JAR, Weber T, Hensen EJM. Structure–Activity Correlations in Hydrodesulfurization Reactions over Ni-Promoted Mo x W (1–x) S2/Al2O3 Catalysts. ACS Catal;5:7276–87; 2015.
[30] Chen W, Maugé F, van Gestel J, Nie H, Li D, Long X. Effect of modification of the alumina acidity on the properties of supported Mo and CoMo sulfide catalysts. J Catal;304:47–62; 2013.