Temperature Changes in Oil Wells and Its Effect on Tubulars Stress Condition

Peyvand, Aminollah; Fazaelizadeh, Mohammad

Temperature Changes in Oil Wells and Its Effect on Tubulars Stress Condition

Document Type : Original Research

Authors

A. Peyvand

M. Fazaelizadeh

Department of Petroleum Engineering, Faculty of Chemical Engineering, Tarbiat Modares University, Tehran, Iran

Abstract

Research subject: Prediction of the wellbore temperature during the downhole operations and its effects on the stress condition of the tubulars is one of the important factors in design of the completion, production and stimulation operations in oil and gas wells. Temperature changes during the life of the well can change the stress condition of the pipes inside the well, such as the tubing and the casing, and cause problems such as wellhead displacement or buckling of the tubulars, which is dangerous in both terms of safety of the well and personnel and it can also be economically inefficient.

Research approach: In this study, various operations during the life of a well such as running the completion string, production start-up, the well shut in, acid injection and other common operations in oil wells were simulated in a practical order. Temperature changes during these operations and their effect on the stress condition of the wellbore casing and tubing were investigated.

Main results: The results showed that long-term production of the well causes the most temperature changes in the well. This increase in the temperature reached a maximum value at a depth of 430 ft, which is the mud line depth. Further, because the pipe is fixed, it buckles and creates torque at deeper well depths. The results also showed that the time required for the temperature to be completely stable is about a few months, and this should be taken into account in the tubing pressure test analysis.

Keywords

Temperature Changes

stress

Casing

Tubing

Completion

Production

Subjects

Petroleum Engineering

[1]. Placido J.C., Ademar P., Paulo L., Pasqualino I. and Estefen S., Stress-analysis of casing string submitted to cyclic steam injection, Latin American and Caribbean Petroleum Engineering, 1997, 1-9, (1)1.
[2]. Shahreyar N. and Finley D., Importance of thermal/stress loading analysis for tubulars in HPHT wells. Offshore Technology, 2014, 1-10, 1(1).
[3]. Carpenter C., Thermal/stress-loading analysis for tubulars in HP/HT Wells, Journal of Petroleum Technology, 2014, 108-111, 66(06).
[4]. Lavrov A. and Torsæter M., Thermal Stresses in Annular Cement: Physics and Mechanics of Primary Well Cementing, SpringerBriefs in Petroleum Geoscience & Engineering, 2016, 10-93, 1(1).
[5]. Bellarby J., Well completion design, Elsevier, Oxford, Vol. 56, NO. 1, 275-284, 2009:.
[6]. Liang Q., Casing Thermal Stress and Wellhead Growth Behaviors Analysis, SPE Asia Pacific Oil and Gas Conference and Exhibition, Perth, Australia, October 2012.
[7]. Mitchell R.F., Tubing Buckling:The State of the Art, SPE Drilling & Completion, 2008, 361-370, 23(04).
[8]. Almulhe K., Mrsic Z., Thuwaibi M. and Adesegha R., Temperature Effect on HP Gas Well Integrity: Thermal Wellhead Growth Challenges and Solutions, SPE Asia Pacific Oil & Gas Conference and Exhibition, Virtual, November 2020.
[9] Guo X., Liu J., Dai L., Huang L., Wei A., Fang D. and Zeng L., Safety evaluation method of tubing strings in high-pressure, high-temperature and high-yield gas wells based on FIV analysis, Engineering Failure Analysis, 120, 44-105, 2021.
[10] Landmark, A Halliburton Company, WellCAT manual, Landmark Graphics Corporation, 2003.